CHAPTER 3. TRASSIR IP CAMERA CONFIGURATION
3.3.6.3 «Line crossing» tab
NOTE.
Before the setup, make sure that the camera is installed correctly for the proper operation
of the video analytics module. Check Supplement E. IP Camera placement for camera
installation recommendations.
Open the
Crossing Line
tab to set up the line crossing detection.
Draw a line on the video using the left mouse button, at the crossing of which the detector
will trigger. The following settings are available for the Line Crossing Detector:
Setting
Description
Sensitivity
Specify the detector's sensitivity, from
0
to
4
. The higher the value is, the more
sensitive is the detector.
Trigger blink
Set the flag so the specified border start flashing on video when the detector is
triggered.
Scene mode
Select the detector's operation mode:
Indoor
or
Outdoor
.
Direction
Set the direction of the specified border crossing at which the alarm event will
be triggered:
A - > B
— left to right;
B - > A
— right to left;
A < - > B
— either way.
Press
Save
to save the settings.
Press
Reset
to reset current detections settings.
116
User manual for TRASSIR IP cameras
Summary of Contents for TR-D4D2
