MICROPHONE CONNECTION
1. Connect small lapel-type microphone into the corresponding 3.5mm Top
Panel Socket.
2. Ensure that the Battery Compartment
MIC/INST
switch is set to
Mic
position.
3. Clip the microphone to your clothing (normally Tie or Jacket Lapel). Route
the mic cable so as to avoid undue strain or friction. Try and keep the mic
cable away from the
ANTENNA
The microphone supplied with the S4.16 has an Omni-directional response,
which means it will pick up sounds from all directions. In view of this we
recommend that the microphone is placed as close as possible to the required
sound source.
INSTRUMENT CONNECTION
1. Connect the supplied Instrument cord into the corresponding 3.5mm Top
Panel Socket.
2. Ensure that the battery compartment
MIC/INST
switch is set to
INST
position
BELTPACK GAIN CONTROL ADJUSTMENT
. (Small screw-driver adjust)
If required adjust the Transmitter AF gain control so the signal only very
occasionally allows the
Red AF O/L Peak Led
on the receiver to light.
CHANNEL SELECTION
(Small screw-driver adjust)
With the Transmitter in the
OFF
position, select a channel to correspond with
the Receiver. It is possible to select any of the 16 channels.
(
Factory set to position 1
).
Note
: If the Transmitter Active Channel has
been changed whilst in the
ON
position, it must
be turned
OFF
and then
ON
again to complete
selection.
6
AF GAIN ADJUST
CHANNEL SELECT 16 POSITION
MIC/INSTRUMENT SWITCH
S4.16 ARTWORK_final_1 colour 20/10/06 08:27 Page 10
