5
Channel Indicator
Displays the received channel number.
Note:
•
A dot located at the lower right of both the group and channel indicators flashes if the
“CH IDENTITY” function is set to OFF
•
The “CH.S.” indication is displayed while scanning channels. If another indication is
displayed or the indicator flashes, refer to “Network Function Manual”
Operation Menu Display
Shows results of operation key settings.
For more information, refer to “6. Menu Operation”
Operation Keys
Change menus in the operation menu display, as well as receiver setting items.
For more information, refer to “6. Menu Operation”
Band Indicator [BAND]
Displays whether the band is set to “1” or “2”.
Antenna Attenuator Level Indicator [ANT ATT A, ANT ATT B]
Displays the set attenuator level in three increments (“0,” “–10” and “–20dB”).
For normal operation leave attenuator in “0” position.
RF Cascade Indicator [RF CASCADE]
Cascade-connected antennas are automatically identified by corresponding LEDs. Refer to
“7. Sharing an Antenna Between Two Receivers”.
Note:
Indicators for band, antenna attenuator level and RF cascade switch from
steady ON to flashing if a digital audio output clock signal supply error
occurs. Refer to “6.3.6. Word Clock Settings”.
Network Status Indicator [LINK/ACT]
Is lit when a network is connected.
Flashes during data transmission or reception.
Network Status Indicator [FULL/COL]
LED lights when network is in full duplex communication mode.
Flashes when data interference (collision) is detected.
Remains unlit while half-duplex communications are in progress between the receiver and
network (PC).
