Installation
Instructions
Aero 60/90/130
Release 3.0
PAGE 14
AERO 130
Bill of Materials for Setup System 9902-30-000
No. Description
Part number Aero 130
1
Setup Table
9902-30-001
2
ExpressLiner
9260-30-003
3
SpaceFrame
926038100
4
Magnetic Cup Clamp 9902-30-002
5
Cliché
Contact Trans Tech
3.2 Installation of the Cliché and Ink Cup
Thumb
Screw
Illustration 2-2. Ink cup assembled on assembly table
When preparing the ink cup to be placed into the machine for printing, proceed as described in the
following instruction:
1.
Insert both ‘MAGNETIC CUP CLAMPS’ (4) with the top down into the ‘SETUP TABLE’ (1) Tighten thumb
screws snuggly to retain clamps.
2.
Place the ExpressLiner (2) with the opening up into the SpaceFrame (3)
3.
Place SpaceFrame assembly into ‘MAGNETIC CUP CLAMPS’ with both dowel pins engaged into the receiver
pockets of the cup.
4.
Fill ExpressLiner (2) with ink to desired fill level.
5.
Place the ‘CLICHÉ’ (5) carefully with the image facing down. Slide cliché back until it is located firmly against
the back and side stops on the ‘SETUP TABLE’ (1)
6.
Loosen thumb screws and carefully lift the ink cup/cliché assembly out of the SETUP TABLE
