TS-‐NX/CL
INSTALLATION MANUAL
Page 46
11 CHANGING PARAMETERS USING THE SMS
COMMANDS
All programming parameters for TS-NX/CL can also be sent by SMS command.
Each SMS command should start and stop with semicolon. If the confirmation SMS
is needed, put “+” at the beginning of the command SMS.
The first SMS is SMS with telephone numbers (TN1 – TN4). If you would like to
check which telephone numbers are programmed in TS-NX/CL please use the
following command:
;PTN;
Return SMS is (example):
;TN1=0;TN2=0;
If you would like to enter telephone numbers in to TS-NX/CL you can use the
following example:
;TN1=040713470;TN2=+38643364850;
If you would like to receive confirmation SMS write “+” before SMS command:
;+TN1=040713470;TN2=+38643364850;
Return SMS from TS-NX/CL is:
;TN1=040713470;TN2=+38643364850;
NOTE
You can use the same programming procedure for all
parameters.
It is also possible to change different parameters with one SMS. Consider that the
SMS message should not be longer than 160 characters (included space
characters).
If you would like to change the following parameters TN1, IN1, IN2, OS1, OS2;
ID1, LN1 and CRE and would like to receive confirmation SMS, try next example:
;+TN1=+38640713470;IN1=1;IN2=1;OS1=15;OS2=1;ID1=120;LN1=1;
