14
S4TEF10xx-10x
7
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
[email protected] -- Click the “Transition Now” link for a live Web chat.
Installation — Continued
Hardware/Software Jumper
The 3-pin header (J11) is inside is located near the back end of the upper circuit
board.
Hardware
The Device mode is determined by the switch
settings .
Software
The Device mode is determined by the most-
recently saved, on-board microprocessor
settings.
H
J11
S
H
S
J11
1
2
3
1
2
3
Pins
Hardware Mode
Software Mode
To set the jumper:
1.
Using a small screwdriver, remove the
four (4) screws that secure the cover
and carefully remove the cover from
the Device.
2.
Locate the 3-pin header (J11).
3.
Using small needle nose pliers or
similar device, move the jumper to the
desired position (
see above).
4.
Carefully replace the cover on the
Device and replace the four (4) screws
that secure the cover to the Device.
Power the Device
1.
Connect the barrel connector on the power adapter to the Device’s power port
(located on the back of the Device)
.
2.
Connect the power adapter plug to AC power.
3.
Verify that the Device is powered by observing the illuminated LED power
indicator light.
Note:
For DC power, consult the user’s guide for the Transition Networks
SPS1872-xx DC external power supply.
Cable Specifications — Continued
RS-232 Cable
(included)
Connectors:
6-pin DIN and DB-9
Gauge:
24 to 22 AWG
Attenuation:
20 dB/1000 ft. @ 10 MHz
Differential characteristic impedance:
100 ohm +/- 10% @ 10 MHz
Maximum cable distance:
<10 ft
(3.2 m)
@ 56 kb/s or higher
1
2
3
4
5
6
7
8
9
3
2
1
4
6
5
Signal Ground 3 & 5
Transmit Signal 1
Receive signal 2
Clear to send 9
2 Receive Data
7 Request Data
3 Transmit Data
5 Signal Ground
DIN 6-Pin
DB-9
