background image

Compliance Information

CISPR22/EN55022 Class A + EN55024
CE Mark

FCC Regulations

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules.  These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment.  This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications.  Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be required to correct the
interference at the user's own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus
set out on the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la Class A prescrites dans le Règlement sur le
brouillage radioélectrique édicté par le ministère des Communications du Canada.

European Regulations
Warning

This is a Class A product.  In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A.  In Wohnbereichen können bei Betrieb
dieses Gerätes Rundfunkstörungen auftreten.  In diesem Fäll ist der Benutzer für
Gegenmaßnahmen verantwortlich.

Attention !

Ceci est un produit de Classe A.  Dans un environment domestique, ce produit risque de
créer des interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les
measures spécifiques appropriées.

Trademark Notice

All trademarks and registered trademarks are the property of their respective owners.

Copyright Restrictions

© 2004-2005 Transition Networks.
All rights reserved.  No part of this work may be reproduced or used in any form or by any
means - graphic, electronic, or mechanical - without written permission from Transition
Networks.
Printed in the U.S.A.

33280.B

Summary of Contents for CRS4F3111-100








Reviews: