Transition Networks CPSMC0800-100, User Manual

Page: 7 / 30

7
CPSMC08xx-100 PointSystem ™ Chassis
slide-in-modules
2.1.3 Installing the Media Converter Slide-in-Modules
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing the media converter slide-in-module(s) into the chassis.
Failure to observe this caution could result in damage to, and subsequent failure
of, the media converter slide-in-module(s).
NOTE: The media converter slide-in-modules can be installed in any installation
slot, in any order.
To install the media converter slide-in-module into the CPSMC08xx-100 chassis:
1. Remove the protective plate from the installation slot by removing the one (1)
screw that secures the plate to the front of the chassis.
NOTE: If the slide-in-module requires two slots, remove the protective plates
from two (2) adjacent installation slots.
2. Align the slide-in-module with the chassis installation slot so that the panel
fastener screw is at the left of the slide-in-module.
3. Carefully slide the slide-in-module into the installation slot, while aligning the
module’s circuit board with the installation guides.
NOTE: Ensure that the slide-in-module is firmly seated inside the chassis.
4. Push in and rotate the attached panel fastener screw clockwise to secure the
slide-in-module to the chassis.
5. Repeat steps 1 through 4 for additional slide-in-module(s).
24 hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
RX TX
LNK
PWR RESET
DB-9
CFETF1
10
SPD
PWR
FRX
CRX
FLNK CLNK
10/100TX
RX TX
10/100SX
LKS
PWR
LKM
Multimode
Singlemode TX RX TX RX
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX
RX
TX
10/100SX CPSMC-0800
8-Slot Chassis
Mpls, MN 55344 Mpls, MN 55344
Input Power: Input Power:
110-240 VAC
110-240 VAC
1.6A max. (60W max)
1.6A max. (60W max)
50/60 Hz
50/60 Hz
LKS
PWR
LKM
Multimode Singlemode
TX RX TX RX
Panel Fastener Screw