Model 0403
8
7
Ethernet™ Pocket Hub™
Connecting 10Base2 Cable
NOTE: 10Base2 cable MUST be properly terminated. Failure to
terminate 10Base2 cable using 50 ohm terminators will cause data
transfer to fail.
The 10Base2 segment MUST be grounded to “earth ground”.
Up to thirty 10Base2 connections can be made in any one segment.
Connecting 10BaseT Cable
To connect 10BaseT Cable to Pocket Hub RJ-45 connectors:
1. Locate or build 10BaseT cables with the following
characteristics:
•
802.3 compliant (See page 14)
•
correct (straight through or crossover) cable configuration
for site installation (See page 6)
•
male RJ-45 plug connectors installed at both cable ends.
2. Connect male RJ-45 plug connector at one end of 10BaseT
cable to Pocket Hub RJ-45 jack connector.
3. Connect male RJ-45 plug connector at other end of 10BaseT
cable to DTE terminal RJ-45 jack connector (using straight
through cable orientation) or to Pocket Hub RJ-45 jack
connector (using crossover cable orientation). NOTE:
Examples are provided in the pages that follow.
3. INSTALLATION
NOTE: 0403 Ethernet Pocket Hub Link Integrity cannot be
disabled. All devices connected to the Pocket Hub MUST
have link functions enabled.
To install the 0403 Ethernet Pocket Hub:
• Unpack the 0403 Pocket Hub.
•
Connect 10Base2 Cable to the 0403 Pocket Hub.
•
Connect 10BaseT Cable to the 0403 Pocket Hub.
•
Connect the 0403 Pocket Hub to power.
Direction is provided in the pages that follow.
Unpacking the 0403 Pocket Hub
The 0403 Ethernet Pocket Hub packing contents should include the
following:
Item
Part Number
0403 Pocket Hub
E-TBT-HB-0403
Power Supply Adapter
3518, 3517, 3516, 3515, or 3514,
(depending upon power configuration
in country where installed)
User’s Guide
7349
Ethernet™
Pocket Hub™
n
e
t
w
o
r
k
s
T
R
A
N
S
I
T
I
O
N
Mpls, MN 55344
Ethernet™
Pocket Hub™
Ethernet™
Pocket Hub™
50 ohm terminator
50 ohm terminator
n
e
t
w
o
r
k
s
T
R
A
N
S
I
T
I
O
N
Mpls, MN 55344
n
e
t
w
o
r
k
s
T
R
A
N
S
I
T
I
O
N
Mpls, MN 55344
