CONGLOMKB .COM
Please contact
cs@conglomkb .com
or
1-877-333-0098
for further assistance .
ENGLISH
11
Care and Cleaning
Your utility cabinet is manufactured with the highest grade materials and will provide you many years of
enjoyment with the proper care .
SINK
Do:
Do Not:
- After use, always rinse your sink with tap water
to dilute and remove deposits .
- Towel dry after use whenever possible to
prevent water spots . Should water spots occur,
clean with a mild solution of vinegar and water
followed by a thorough rinse .
- Use liquid soap, a general household cleaner,
or a weak solution of vinegar and water for
regular cleaning .
- Only use plastic scouring pads recommended for
use in stainless steel sinks, and only use them in
the bowl of the sink . Scrub in the direction of the
satin finish lines.
- Do not allow any food, detergent, soap or grease
to dry or sit for extended periods of time on the
surface of the sink .
- Never use abrasive cleaning products, as they
will dull and scratch the finish.
- Do not use scouring pads on the deck, as they
will dull the finish.
- Never use steel wool pads or leave steel/cast
iron pans in your sink for extended periods of
time, as they will leave iron particles on the sink,
which can cause corrosion .
- Never use chlorine-based cleaners in your
new sink, they could lead to rust spots and
discolouration . If you must use them, rinse
sink thoroughly with fresh water immediately
after use .
- If any chemicals or glue make contact with the
sink during installation, wipe clean and rinse
thoroughly with fresh water .
SCRATCH, SPOT, AND BLEMISH REMOVAL AND SURFACE RESTORATION:
Little rust spots and blemishes that periodically appear in the sink are typically the result of the steel interacting with the
chemicals found in the vast spectrum of substances that sinks are commonly exposed to . They may also get transferred from
other objects placed or left in the sink . Scratches are the result of regular wear and tear .
To remove scratches, spots, and blemishes from the sink, rub them with a non-metallic scouring pad (e.g. Scotch-Brite
®
)
combined with a mild abrasive cleaner (e.g. Vim
®
or Barkeeper’s Friend
®
). Always rub the surfaces in the direction of the grain of
the steel. When finished, rinse the sink with water and dry it with a towel to allow the sink to form a protective outer layer. This
procedure can also be used to renew all of the surfaces of the sink .
CABINET
Do:
Do Not:
- Remove dust and dry dirt with a soft,
damp cloth .
- Clean grease, oil, paint and ink stains with
isopropyl (rubbing alcohol). Immediately rinse
with water after stain removal .
- Do not allow your cabinet surface to come
into contact with products such as acetone
(nail polish remover), nail polish, dry cleaning
solution, lacquer thinners, gasoline, pine oil, etc .
- Use caution when using sharp instruments that
may fall and scratch the surface .
