7
Installing a Hard Drive
︱
The StoreJet 35U3 hard drive enclosure only works with 3.5” SATA Hard Disk Drives.
Installing a Hard Drive
If you purchased a Transcend StoreJet 35U3 hard drive enclosure that does not have a SATA hard drive
already installed, please read this section for installation instructions. If a hard drive is already installed, you
can skip to the “Connecting to a Computer” section.
1.
Remove all eight screws from the back and front of the StoreJet 35U3, and then remove both the front
and back metal covers.
2.
Place 3.5” SATA hard drive (face-up) into the enclosure so that it lays flat, with its SATA connectors
facing the StoreJet 35U3’s circuit board. Assure that the SATA connectors on the hard drive and the
circuit board are aligned properly.
3.
Connect the hard drive to the StoreJet 35U3 by
gently
sliding it towards the circuit board’s SATA
connectors.
Do NOT connect the hard drive at an angle,
which may damage it.
