Transcell Technology WEIGHBLOK, Setup & Operation

Page: 10 / 11

Manual- Weighblok Rev 1 4-2-03
10
975 Deerfield Parkway 800-503-9180 www.transcell.net
Buffalo Grove, IL 60089 847-419-1515 transcell@transcell.net
LCD
Enunciator
MEANING
è
0
ç
Better known as the
“
Center of Zero
”
enunciator, this light is active
whenever the displayed weight is within
±
0.25 divisions of true zero.
N
Indicates that the indicator is displaying net weight.
G Indicates that the indicator is displaying gross weight.
T Indicates that a tare weight has been established in the system.
lb, kg Indicates the unit of the displayed weight (normally disabled).
bAtt Indicates a low battery condition. Re-charge the battery or replace if alkaline
batteries.
Indicates stable weighing.
Weighblok Enunciator Definitions. Shown above is the LCD display. Before reading the value the stable indicator must be
”
on
”
.
If not, wait a few seconds until it appears.
Basic scale use
1. Press ON to start the scale.
2. If necessary, press ZERO to obtain a weight reading of zero.
3. Press OFF to switch off the scale. Hold 3 seconds.
4. The scale switches off automatically after 10 minutes when not in use
Weighing (e.g. a cylinder with liquid)
1. Unload scale and press ZERO.
2. Place the object (cylinder, container, etc) on the scale
’
s platter and allow the weight indication to stabilize. If the item
weight exceeds the scale
’
s weight capacity, it displays
“ rrrrrr ”
. Press TARE to zero the Scale. The display
shows zero weight and turns the NET enunciator on.
3. NET/GROSS toggles between Gross and Net weight display only if a Tare has been established.
4.
“
Dot
”
. Extended graduation.
General advice
When the Scale is not in use and is transported between different working places, we recommend usage of a case or any
other protection against vibrations and other hard environmental conditions. Protect the scale with a plastic bag if there is
any risk of working in a wet environment.
ON
PRINT
NET
GROSS
OFF
ZERO
TARE