TransAct ITHACA 9800, Maintenance Manual

Page: 5 / 70

100-13732 - Rev B Page iii
Federal Communications Commission Radio
Frequency Interference Statement
This equipment, when not transmitting, has been tested and found to comply
with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and, used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference
at his own expense.
The transmitting equipment in this product has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
FCC Wireless Notice
This product emits radio frequency energy, but the radiated power is far below
the FCC radio frequency exposure limits. Never the less the device should be
used in a manner (assembled or disassembled) that the potential for human
contact with the antenna during operation is minimized.
To meet FCC’s RF exposure rules and regulations:
1. Do not co-locate or operate this product in conjunction with another
antenna or transmitter.
2. Typical distance from the body of the user should be at least 20cm.
Output Power into Antenna & RF Exposure
Calculations for this device are based on highest power measurement and the
highest gain of the antenna. Limit for MPE (from FCC part 1.1310 table 1) is
1.0 mW/cm
2
for 2400MHz.