Rev G
Page 9
Chapter 3: Configurable Options-Specifications
Ticket Supply Box Specifications
Power and Interface Communications
The Model 750 with a Ticket Supply Box option uses the J3: 5-Pin connector as the
primary link for the Supply Box Ticket Low Sensor’s power and communication.
The J3 connector is located on the printer connector board.
Ticket Low Sensor
All Ticket Supply Box options are configured with a Ticket Low sensor. The Ticket Low
sensor detects when the ticket stack is approximately 45 tickets. A replacement Ticket
Low Sensor can be acquired from Optek. TransAct recommends using the following
Optek Ticket Low Sensor.
Replacement Ticket Low Sensor:
Optek
0PB773T
Signal Levels Needed
VOH 5 VDC NOM
VOL 0.6 - 1.2 VDC @ 5mA
Ticket Present Sensor Specifications
The Model 750 uses the J7: 4-Pin connector as the primary link for the Ticket Present
Sensor’s power and communication. The J7 connector is located on the left front on the
Printer Controller Board. A replacement Ticket Present Sensor Assembly can be
acquired from TransAct’s Ithaca Facility. TransAct recommends using the following
Ticket Present Sensor.
Ticket Present Sensor Assembly:
75-00251
Bezel Assembly Exit Lamp Board Specifications
A lamp board is included with the Ithaca Series 700 Bezel Assembly. The lamp is used to
illuminate a user instruction panel and the ticket exit. The lamp board comes with 2 one-
watt bulbs for use at 13 VDC. Other bulbs may be used for other voltage and wattage,
provided the current does not exceed design parameters.
Power Requirements
Voltage
13 VDC
±
10%
Current
150 mA NOM
