Copyright © 1999 Trango Systems, Inc. All rights reserved.
8
INTERFERENCE
If interference such as lines in the pictures is observed, changing the transmission
channel may cure the problem.
Also, AC generators in close proximity to the transmitter or receiver may cause lines
in the picture. Move the unit away from the source of the interference.
NO PICTURE
Check that the transmit and receive channels are set the same, and make sure the
LED is glowing.
Verify all connectors are tight.
POOR PICTURE QUALITY
Raise transmitter and receiver antennas above ground and away from obstacles and
traffic, including foot traffic.
VIDEO TOO DARK
Make sure that any monitors/peripheral equipment connected to the video source are
set to high impedance termination since the VTX2500 has a built-in 75
Ω
termination.
VIDEO TOO BRIGHT
Make sure that the receiver video output line is terminated with 75
Ω
.
Check the Technical Support section of our website at
http://www.trangosys.com/
for
additional assistance.
