Copyright © 1999 Trango Systems, Inc. All rights reserved.
1
1
• Verify proper operation of camera and monitor/event recorder using coaxial cable prior
to installing wireless link per the diagram below.
2
• Connect the power adapter to the #6 terminals on the transmitter and receiver units per
the picture below.
3
• Install transmitter (VST2500) and receiver (VSR2500) units in desired location to a wall
using the supplied mounting hardware as shown below. For optimum performance the units
should be mounted at a height of 6-7 feet above the ground and no more than 300 feet apart.
4
• Connect the video audio and alarm inputs and outputs, following the color sche mes on
the cables and connectors.
5
• Plug the AC adapters into the wall outlet. The LED on the unit should come on and blink
several times. The numbe r of blinks indicates the channel. Both units must be on the same
channel for proper operation.
6
• Adjust the units until the best picture is obtained. Normally this will occur when the
units are oriented as shown below, but in some cases the best picture may occur when the
units are not aime d directly at each other.
7
• After the picture has been optimized tighten the bracket down using the knob on the side
of the bracket as shown below.
