Command Set Summary
Connections and Power
Trango Broadband Wireless — User Manual TrangoLINK Rev. A for F/W Ver. 1.0
Page 3
Chapter 2
Getting Started
First unpack your MU and RU. It is recommended to first provision and test the radios on the bench before deploying in
the field. This is a particularly useful exercise to the novice user.
Connections and Power
Connection and powering of radios is the same for MUs and RUs.
??
Connect a Cat-5 (straight through) Ethernet cable (we recommend shielded twisted pair) between the ODU (out
door unit) port of the J-box and the RJ-45 connector on the radio. Note that this cable will carry power over
Ethernet (PoE).
??
If connecting to a COMPUTER, use a Cross-Over Ethernet cable from the NET port of the J-box to the
computer’s Ethernet port.
If connecting to a HUB, SWITCH, or ROUTER, use a Straight-Thru cable.
??
Plug the AC adapter into an AC outlet.
Figure 0-3 Wiring Diagram
POWER
ODU
POWER
ODU
NET
LED Indicates
power to J-Box
LED Indicates
power to Radio
Master Unit or Remote Unit
AC Power
CAT-5
Straight-Thru
Cable
20 V
Power
Supply
Network
or
PC
CAT-5
Use cross-over
cable if to PC
Power over Ethernet
J-Box
Use straight-thru cable
if to hub, switch
or router
Both green LEDs on the J-box should be lit, indicating power is present at the J-box as well as the radio.
You are now ready to configure the radio via the Ethernet port.
?
Note: If you can not access the radio management functions via the Ethernet port, it is possible that your PC is not
set up with a properly routable subnet. If you forget the radio’s IP address, or for some other reason can not access
the radio via the Ethernet port, use the Serial Programming cable (supplied with each TrangoLINK kit) and attach
to RJ-11 located behind access cover on bottom of radio.
