Command Set Summary
Procedure to Establish Wireless Link
Trango Broadband Wireless — User Manual TrangoLINK Rev. A for F/W Ver. 1.0
Page 10
Chapter 3
Establishing a Wireless Link
This section describes how to establish a wireless link between MU and RU, using the command line interface.
Procedure to Establish Wireless Link
In order to establish a wireless link, the following parameters must be set.
1. The Remote ID, the MAC ID of the RU, must be set in the MU.
2. The MU’s RF Channel and Polarization must exist in the RU’s channel scan table.
3. The Opmode of the MU is on.
4. The Opmode of the RU is on.
5. Adequate signal strength received at each radio.
If all of these parameters are met, and if the MU and RU are within range - and properly aligned, the wireless link will
automatically establish itself and Ethernet traffic will begin to pass between the radios.
To ensure each of these parameters is met, perform the following steps:
Master Unit
Click the Configuration page link from any page in the Browser Interface.
1. Set IP, subnet, and gateway
2. Fill in the Remote ID with the MAC address of the RU
3. Set channel and polarization
4. Set default opmode to On
5. Update system setting flash memory by clicking Save and Activate Settings
