Trango Broadband Wireless Access5830™ User Manual
User Manual Rev 1
17
Target RSSI From SU
: This parameter specifies the target RSSI from all SU’s to
the AP. Based on this parameter, the AP can power level each SU so that it
receives same level of signal strength from all SU’s, regardless far or near.
Please note that when you set the Target RSSI from SU, you need to consider
AP’s rfrxthreshold. If the rfrxthreshold were higher than the Target RSSI From
SU (says –70dBm for rfrxthreshold and –75dBm for Target RSSI From SU), the AP
would never be able to hear from these SU’s.
We must set the Target RSSI From SU
5dB
higher than the rfrxthreshold. When
the rfrxthreshold is
disabled
, the setting of Target RSSI from SU shall be no less
than
–75dBm
.
MIR Threshold
: This parameter serves 2 purposes. 1) Enable/Disable the MIR
Threshold; 2) Specify the MIR threshold.
??
When MIR Threshold is disabled, the AP will serve MIR for all its SU’s.
??
When MIR Threshold is activated, and the network traffic exceeds the
MIR threshold, the AP will only serve CIR for all its SU’s.
??
When MIR Threshold is activated, and the network traffic does NOT
exceed the MIR threshold, the AP will still serve MIR for all its SU’s.
Site Survey
Page:
This HTML page is used to verify the RF environment the AP is operated in. To
start the survey, please specify the duration of the test (in minutes), and the
channel polarization, then click the
Start Survey Button
.
Please note that the radio
must
be on
off
mode to do site survey.
