Trango Broadband Wireless Access5830™ User Manual
User Manual Rev 1
15
Default Opmode
: This parameter controls the state (ap or off) of the radio
after reboot/power cycle. When the parameter is set to ap, the radio will get
into ap mode automatically after reboot/power cycle.
In case you want to interrupt the boot up routine, you can telnet/HTTP into
the radio within 30 seconds time window. As the result, the radio will stay in
off mode.
Switch (Block Broadcast and Multicast Packets)
: This switch enables/disables
the blocking of Ethernet control packet except ICMP and ARP to reduce the
amount of unnecessary overhead introduced to the wireless link.
Switch (Activate SU to SU Communication)
: This switch enables/disables the
peer-to-peer feature among SU’s through the AP. Before the switch is turned
on, all SU’s that want to communicate with each other have to be assigned to
the same group. (See SU to SU Group)
Switch (Broadcast Time Stamp to SU)
: This parameter is NOT used at this
time. Please leave the default unchaged.
Active Channel
: This parameter specifies the channel number and polarization
the radio operates on.
Remarks
: This parameter documents radio information (i.e. customer name,
address of installation, and so on). Maximum 28 characters can be stored.
Button (Save and Activate Settings)
: This button will save settings mentioned
above to persistent storage, then active them.
Hyperlink (Add Subscriber)
: This hyperlink will take you to Subscriber
Database page.
Hyperlink (Activate Opmode)
: This hyperlink will activate the radio from off
mode to ap mode.
Hyperlink (Reboot System)
: This hyperlink will reboot the system. The radio
will go into the ap/off state based on the setting of Default Opmode. The
whole process will take 60 seconds.
Advanced Setup
Page:
