4
VAV-SVX03A-EN
Literature Contents
This manual describes the operation,
calibration and set-up of VariTrane VAV
Single-Duct and Fan-powered units
with Analog Electronic Controls.
Receiving and Handling
VariTrane units are shipped completely
assembled with the exception of filters
and accessories. Upon receiving,
please inspect each unit and the
components for shipping damage.
General
Information
After receiving the units, complete
the following:
Locate the nameplate and model
number and check that the correct units
have been received.
Inspect the control units and air damper
casing for dents or punctures.
Verify that all options have been
included, such as filters, controls,
heating coils, water valves, etc. Also
check that unit voltages agree with the
building parameters.
Manually rotate the fan (if applicable) to
assure that there are no obstructions
within the housing.
Claims for in-transit damage must be
filed immediately with the delivery
carrier.
For re-heat units, check the coil fins and
make sure the coils are not damaged.
Locate and verify that the correct zone
sensors are with the order. These will
be marked with an orange “Accessories
Enclosed” label. Store in a secure place
until needed. Accessories lost at a
jobsite are NOT covered by Trane’s
warranty.
If a discrepancy occurs between what
was ordered and what is received,
contact your local Trane representative
immediately.
Read the appropriate section in this
manual for installation procedures prior
to actual starting of installation.
NOTICE:
Warnings and Cautions appear at appropriate sections throughout this manual.
Read these carefully.
— Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
— Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
— May also be used to alert reader to a situation that could result
in equipment or property only damage.
WARNING
WARNING
CAUTION
CAUTION
CAUTION:
CAUTION:
