18
BAS-SVX078E-EN
System Setup
Power-up Sequence
The unit initiates a 90 to 120 second power-up sequence. During the sequence, the
Screen Calibration
option is made available for five (5) seconds. However,
Screen Calibration
is available for five (5)
minutes if the screen has never been calibrated and following a
Restore Factory Defaults
command.
Note:
The Pivot thermostat comes factory calibrated.
If the unit screen is not pressed within 5 minutes, the unit defaults to previously stored calibration
settings. The unit can be re-calibrated any time by rebooting the unit.
Note:
Temperature display may be inaccurate until the unit acclimates to ambient room temperature.
This may take up to one (1) hour.
Installation Wizard Overview
The
Installation Wizard
displays when:
•
The unit is initially powered on.
•
The
Restore Factory Defaults
function is invoked.
•
Selected from Service Menu (
Home > Menu > Service > Technician Access
(press for 5 seconds)
>
Proceed > Service Menu > Installation Wizard or Installer Setup
).
Note:
A PIN access code may have been previously set up on the thermostat by the building owner,
which may restrict access to the Menu screen and/or Service screen. If PIN access has been
set up, the thermostat will display a notification when attempting to access the Menu or
Service screen. In this case, the technician must obtain the PIN access code from the
building owner or request to have the thermostat unlocked.
The wizard setup guides the installer through:
•
Time/Date
Set the current time/date and set Daylight Saving Time to On/Off.
•
Installer Setup
Configure the basic equipment components installed and customize how the unit operates.
•
Service Reminders
Various service reminders can be enabled based on the system configuration, such as, System,
Filter, Ventilation , UV Light, and Humidifier. The frequency can be selected based on calendar
or runtime days.
•
Contractor Identification Code
The contractor identification code is used to populate the contractor contact information and
associate the unit with a Pivot contractor portal account. The contractors primary telephone
number is entered to activate this feature.
Note:
Only units connected to the Internet will auto-populate the contractor information.
Installer Setup Screens
Individual parameters are configured and edited from the Installer Setup screens. Use the up/down
arrows to scroll through groups of settings. To change a setting within a specific group, press
Edit
and
then press
Next
to navigate to the desired setting. Press
Save
to retain changes or
Exit
to discard
changes.
Summary of Contents for Pivot BAYSTAT814 Series
Page 46: ...46 BAS SVX078E EN Notes...
Page 47: ...BAS SVX078E EN 47 Notes...
