Picco R32
Inverter air/water heat pumps with axial fan
11
CAUTION: The unit must be installed so as to allow free movement for repair and maintenance operations. The warranty
does not cover costs for platforms or other lifting equipment needed for any interventions.
CAUTION: The unit must be installed so as to allow free movement for repair and maintenance operations. The warranty
does not cover costs for platforms or other lifting equipment needed for any interventions.
All the maintenance operations and tests must be done by QUALIFIED PERSONNEL ONLY.
Before any operation on the unit, make sure that power is disconnected.
Do not use equipment to speed up the defrost process or for cleaning except for those recommended by the manufacturer.
Do not perforate or burn.
CAUTION: There are some moving components inside the unit. Pay the utmost attention when operating in their vicinity,
even if power is disconnected.
The heads and delivery pipe of the compressor are normally quite hot.
Be careful when working near the condensing coils.
The aluminium fins are very sharp and can cause serious injuries.
After the maintenance operations, close the panels by fixing them with screws.
5.2
TRANSPORT AND STORAGE LIMIT TEMPERATURE
Minimum transport/storage temperature [°C]
- 10 °C
Maximum transport/storage temperature [°C]
+ 50 °C
5.3
LIFTING AND HANDLING
The handling must be performed by qualified personnel, properly equipped with appropriate tools to the weight and the encumbrance of the
unit, in compliance with safety regulations of accident preventing.
It is recommended:
1. Check the weight on unit technical label or on table of tecnical data;
2. Check moving the unit there are no disconnected paths, ramps, steps, doors that could affect the movement and damage the unit;
3. Make sure the unit stands while moving;
4. Before handling the unit, check that the equipment is suitable for lifting and preserving the integrity of the unit;
5. Check the unit center of gravity and align it with lifting point;
6. Perform lifting only by one of the listed procedures;
7. Before starting handling make sure the unit is in stable equilibrium.
5.3.1
LIFTING MODE
Only perform lifting operations using one of the methods listed below:
•
forklift truck;
•
thick lifting tubes according to EN 355 and EN 10297-1, thick lifting tubes acc ropes/chains;
•
lifting slings (available as an accessory) + ropes/ sling bar. Ensure that the lifting ropes are tensioned gradually and check that they
are correctly positioned.
Summary of Contents for Picco R32-140
Page 44: ......
