10
CLCH-SVX03C-EN
Pre-Installation Requirements
Assembly Hardware
Trane air handlers ship with all necessary assembly hardware and gasket material. This hardware
is packaged in either a clear plastic envelope or cardboard box and can be found inside the fan,
mixing box, or access module. If there is not enough space inside the module, a crate or pallet will
be loaded onto the bed of the truck. Check the Parts List on the Field Assembly drawing against the
contents of the crate. Do not proceed with unit assembly until verification that all materials are
present. Sometimes it is necessary to use more than one section to ship hardware. Please check
all sections thoroughly before contacting your local Trane sales engineer to report missing
hardware.
Resolving Shipping Damage
Trane air handlers ship free on board (FOB) ship dock, meaning that the unit belongs to the
customer the moment the delivery truck leaves the factory shipping dock. If damage has occurred
to the unit during shipment, follow these instructions:
Note:
Trane is not responsible for shipping damage.
1.
Make specific notation, describing the damage, on the freight bill. Take photos of the damaged
material, if possible.
2. Report all claims of shipping damage to the delivering carrier immediately and coordinate
carrier inspection, if necessary.
Note:
: Do not attempt to repair the unit without consulting the delivering carrier.
3. Notify your Trane sales representative of the damage and arrange for repair.
Note:
Do not attempt to repair the unit without consulting your Trane sales representative.
4. Keep the damaged material in the same location as it was received.
Note:
It is the receiver's responsibility to provide reasonable evidence that concealed damage was
not incurred after delivery.
Job Site Storage Recommendations
M-Series units and/or field-installed accessories that must be stored for a period of time before
installations must be protected from the elements. A controlled indoor environment is
recommended for proper storage.
Note:
The warranty does not cover damage to the unit or controls due to negligence during
storage.
General Storage
The unit controller and all other electrical/electronic components should be stored in conditions of
-20ºF to 120
°
F and 5 to 95 percent relative humidity, non-condensing. Electrical components are
not moisture-tolerant. Factory protective coverings, such as shrink-wrap material, should be
removed within 48 hours of receiving the unit, and prior to storage.