5
UNT-SVN009-EN
Pull
Pull
Unit Installation
Indoor Unit
1. Select a location to route piping,
wiring and drain pipe.
2. Make a hole in the wall using a key
hole saw or hole-cutting drill
attachment.
The hole should be made at a
slight downward slant to the
outdoor side (Figure 5).
Before cutting, check that no pipes
or studs are directly behind the
place to be cut. Avoid areas where
electrical wiring or conduits are
located.
3. Place the unit on a solid and
level foundation.
4. Tubing, wiring through and drain
pipe of low wall and floor
mounted units can be routed,
rear or right side of unit when
facing front.
Ceiling mounted can be routed
straight downward.
5. Pull air filters upward (Figure 6).
0.83"(17.5)
0.83"(17.5)
8.5"(215)
B
A
6. Unscrew at the return grille
(Figure 7).
7. Unscrew at the grille bottom
hinges, pull out the screw, and
unscrew at the side panel front
(Figure 8). Then, push down on
the side panel front and pull up
(Figure 9).
Note:
=
A
0.49" x 1.575" - 4 SLOT
(Mounting hole) (12.5 mm 40.0 mm)
Unit Size
B
CFEB 04-06
36.2" (914)
CFEB 08
46.1" (1,164)
CFEB 10-12
55.9" (1,414)
CFEB 14
65.7" (1,664)
CFEB 16-20
75.6" (1,914)
8. Place or hang the unit at the
selected position.
9. Replace both right and left side
panels, and the return grille after
the installation of wiring, tubing
and piping is complete.
Outdoor Unit
See the proper installation method
provided in the Installation Manual
for the outdoor unit.
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 5
Indoor side
Outdoor side
UNT-SVN009-EN.p65
9/9/09, 9:57 AM
5
