Trane Technologies Thermo King SLXi DRC, Installation Manual

Page: 31 / 48

TK 56403-2-IM-EN
31
Fuel Line Installation
IIm mp po orrtta an ntt:: Use two wrenches (where applicable) when tightening fuel line fittings to help prevent stripping threads.
N No otte e:: All SLXi units come with “Quick connect fittings” . These need to be removed for North America use. See
( “Installing the Fuel lines – DRC Applications,” p. 28 ) for instructions
1. Route the 3 3//8 8” ” F FU UE EL L S SU UP PP PL LY Y line down to the fuel tank fitting.
2. Route the 1 1//4 4” ” F FU UE EL L R RE ET TU UR RN N line down to the fuel tank fitting.
3. Install the provided brass hose fittings over the ends of the fuel lines, tighten the compression nut securely, connect
to the 90 degree brass adaptor fittings and into the tank as shown below.
1 Compression Nut
2 Compression Ring
3 Compression sleeve
4 Brass Adapter fitting
4. Remove plastic cap from the fuel vent and point the outlet to the rear of the container.
• IIM MP PO OR RT TA AN NT T:: T Th he e ffa acctto orry y iin nsstta alllle ed d ffu ue ell tta an nkk a aiirr v ve en ntt m mu usstt b be e iin n p plla acce e a an nd d ffu un nccttiio on na all ffo orr tth he e T Th he errm mo o K Kiin ng g
u un niitt’’ss ffu ue ell ssy ysstte em m tto o o op pe erra atte e cco orrrre eccttlly y a an nd d ffo orr tth he e ffu ue ell tta an nkk tto o rre em ma aiin n iin n cco om mp plliia an ncce e w wiitth h F Fe ed de erra all M Mo otto orr
C Ca arrrriie err S Sa affe etty y A Ad dm miin niissttrra attiio on n ssp pe ecciiffiicca attiio on nss ((ttiittlle e 4 49 9,, p pa arra ag grra ap ph h 3 39 93 3..6 67 7)).. A A p pllu ug gg ge ed d o orr rre essttrriicctte ed d ffu ue ell tta an nkk
a aiirr v ve en ntt cca an n rre essu ulltt iin n p prre em ma attu urre e d da am ma ag ge e tto o tth he e ffu ue ell p pu um mp p a an nd d cco ou ulld d a allsso o cca au usse e sse ev ve erre e d da am ma ag ge e tto o tth he e ffu ue ell
tta an nkk.. N NE EV VE ER R rre em mo ov ve e o orr iin nsstta allll a an ny y o otth he err cco om mp po on ne en ntt iin n p plla acce e o off tth he e ffu ue ell tta an nkk a aiirr v ve en ntt..
N No otte e:: Add a sufficient amount of fuel (1/4 tank) to allow the unit to run for 8 to 12 hours during engine break-in and pre-
delivery procedures.
5. Bandwrap the fuel lines to the SLXi frame after routing is complete.
IIn nsstta alllliin ng g tth he e F Fu ue ell lliin ne ess –– D DR RC C A Ap pp plliicca attiio on nss