29
Mounting the tire
WARNING!
It is utmost important to check the tire and rim to prevent tire explosion during the
inflating operations. Before beginning mounting operation, make sure that:
The tire and cord fabric are not damaged. If you note defects DO NOT mount the tire.
The rim is without dents and is not warped. Pay attention to alloy rims, internal micro-cracks are
not visible to naked eye. This can compromise the rim and can also be a source of danger
especially during inflation.
The diameter of the rim and tire are exactly the same. NEVER try to mount a tire on a rim if you
cannot identify the diameter of both.
-
Lubricate the tire beads with the Fabbri tire grease in order to avoid damaging them and to
facilitate the mounting operations.
WARNING!
During rim locking NEVER keep your hands under the tire. For a correct locking
operation set the tire exactly in the middle of turntable.
-
Lock the rim on the turntable.
WARNING!
Never keep your hands onto the wheel: the arm recovery to “working position” could
set the operator at risk of hand crushing between rim and mounting head.
To prevent industrial accidents, keep hands and other parts of the body as far as possible from the
tool arm when the table top is turning.
CAUTION! Demounting and mounting are always done with the clockwise turntable rotation.
Anticlockwise rotation is used only to correct operator’s errors or if the turntable stalls.
-
Move the tire so that the bead passes below the front section of the mounting head and is
brought up against the edge of the rear section of the mounting head itself (fig.20B).
-
Keeping the tire bead pressed down into the wheel rim channel with your hands, press down
on the pedal A(fig.17) to rotate the turntable clockwise. Continue until you have covered the
entire circumference of the wheel rim (fig.21A).
-
Insert the inner tube if there is one and repeat the same operations to mount the upper side
of the tire (fig.22).
Fig. 18
Fig. 21
Fig. 22
Fig. 20
Summary of Contents for ZH650
