www.TrailFX.com
Page
5
of
8
Rev022818
5.
Move along the side of the body panel to the center mounting location,
(Figure 13)
. Repeat the appropriate
Step 3
to install
the driver side center Bracket,
(Figure 14)
. Select (1) driver side front/center Support Bracket. Repeat
Step 4
to attach the
Support Bracket to the front of the center bracket and factory holes (if equipped) in the pinch weld.
6.
Move to the rear location,
(Figure 15)
. Repeat
Step 3
to install the rear Mounting Bracket,
(Figure 16)
. Select the driver
side rear Support Bracket. Repeat
Step 4
to attach the Support Bracket to the rear of the rear Bracket and factory holes, (if
equipped), in the pinch weld,
(Figure 17)
.
IMPORTANT:
The driver/left rear Mounting Bracket and Support Bracket are the
same as the Passenger/right front and center Brackets, (see illustration page 1).
7.
Once all (3) Brackets have been installed, select (1) Running Board. Place the Running Board on top of the Brackets. Select
(3) 8mm Double Bolt Plates. Insert the Bolt Plates into the channels in the bottom of the Running Board closest to the
Brackets,
(Figure 18)
. Lift the Running Board up and guide the studs through the Brackets.
(Fig 13) Driver/Left center location
Front
(Fig 14) Driver/Left center Brackets installed
Front
8mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut
(Fig 15) Driver/Left rear mounting location
Rear
IMPORTANT: 2009-2010 models without holes
in pinch weld will require drilling 1/4” holes
through pinch weld to attach Support
Brackets. Do complete installation of Running
Boards first and level Running Boards before
drilling holes for Support Brackets.
(Fig 16) Driver/Left rear Mounting Brackets
(same as passenger/right front and center)
Rear
(Fig 17 Driver/Left rear Brackets installed
Rear
