www.TrailFX.com
Page
7
of
8
Rev022818
10.
Move to the passenger side of the vehicle. Remove tape covering front, center and rear locations. Repeat
Steps 2
—9
for
passenger side Running Board installation.
NOTE
: Refer to the illustration on
Page 1
to identify the correct Mounting Bracket
for each of the remaining locations.
11.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Front
(2) 6mm Hex Bolts
(4) 6mm Flat Washers
(2) 6mm Nylon Lock Nuts
(Fig 12) Driver side front Bracket assembly
8mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut
(Fig 17 Driver/Left rear Brackets installed
Rear
Installation Complete
(Fig 14) Driver/Left center Brackets installed
Front
8mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut