If the monitor doesn't display images within a few
seconds after touching the starting button:
1. The battery in the camera may be depleted and require recharging.
1. Check to make sure the power source is active (if your cigarette lighter is
switched with vehicle ignition, your monitor will only work when the engine
is running or the key in the ON position).
2. Check to make sure the fuse and power cord are in working order.
If the video image does not last the setting time:
Recharge the camera battery.
The Setting Time of Image-Display:
45 Seconds each time
2.
The camera may be in ‘sleep mode’ and can be activated by ‘light
vibration’; start the vehicle engine, or open/close the vehicle door.
If
there’s no
image
after
touching
the Touch-
Switch
in
a ‘quiet
environment’
(no
vibration
at
all),
such
as
when testing
inside.
‘Vibrate’
the
camera,
touch
the
powered
Monitor
Touch-Switch
quickly
(within
3
minutes
of
‘vibrating’ the camera)
to
wake
up
the
sleeping
camera.
Once
installated
and in use,
’small
vibrations’
will occur, when
doors
are opened,
people
touch
the
vehicle and even
the
engine
operation.
Therefore the camera will be in standby mode.
Check
if
the
camera
solar
panels
are
covered
with
mud,
water,
dirt,
etc.
Please
use
a soft
cloth
moistened
with
a
neutral
detergent
solution
to
remove
dust
or
stains,
so
as
not
to
affect
the
solar
power
generation
efficiency.
Do
not
use
solvents
or
chemical
materials
to
clean
or
wipe
the
Digi-Lite™ Solar
camera
(including
the
lens
and
all
solar
panels)
If
necessary,
use
a
soft
cloth
moistened
with
a
neutral
detergent
solution
to
remove
dust
or
stains.
Please
regularly
clean
the
camera lens and
the
solar
panels.
