Operators manual for the Pentruder 8 – 20HF IQ and Pentpak 427
Page 14
Tractive Support
Alternative position
of track feet:
In certain circumstances it is impossible to mount the track feet as shown
in the picture below. If the track feet must be mounted differently, this may
affect the stability of the track. If this is the case, more track feet should
be fitted to spread the load and increase stability.
Adjusting the height of
the track feet:
The height of the fork can be adjusted totally 12 mm by turning the fork
CW or CCW, to compensate for irregularities on the wall. Please be sure
that the fork is not threaded all the way out before the track is mounted.
Leave at least ½ a turn from the fully out or in position.
Mounting the track:
The track is mounted using clamp screws which fit into the yoke of the
track foot. At least two feet must be used to mount one track.
The clamp screws are fitted in T-slot clamps running in T-slots at the rear
of the tracks. These T-slot clamps can be locked in any position by
means of a knurled knob.
A clamp screw is fitted in to the yoke and should be tightened to 50 Nm
(fairly hard) with a 19 mm (3/4”) spanner.
Warning!
Be careful to position the clamp screw in the countersink of the yoke on the track foot. This countersink
Joining two or more
tracks together:
If tracks are to be joined when making long cuts the yoke of the mounting foot should be positioned
Countersink
Clamp screw
Track foot
Knurled knob
