© 2016 Tractel
®
Inc. All rights reserved.
17
4.3 ASSEMBLY OF END STIRRUPS AND HOISTS
(one line system shown) (for stirrup model
STMSTE01 (ES01) and PMR0331D (ES02))
a. Align the stirrup pin holes. Insert four gravity lock pins
from the inside of the platform. Do not hammer or force
the pins into place.
b. Use only the 5/8 inch diameter gravity lock pins and
connectors supplied by Tractel. Make sure that the pins
are not worn, bent or otherwise damaged. Never
substitute alternative pins or bolts.
c. After each pin is installed, ensure that the gravity lock is
rotated facing down vertically to prevent the pin from
dislodging. (see fig. 9 to fig. 12, page 16)
d. Bring a hoist to the top of the end stirrup.
e. Attach the hoist to the stirrup using mounting hardware
provided by your supplier.
f. The saddle mounts the hoist controls inbound to the stage.
See fig. 13 to 16a.
Fig. 14
Universal End
Stirrup
Inside and Right
View
Fig. 13
Universal End Stirrup
Outside and Left View
PMR0331D (ES02)
Fig. 15
End Stirrup
Outside and Left View
STMSTE01 (ES01)
PMR0332 end stirrup Safway
- Hoists should be disconnected from the Stirrup for
storage and transportation
- In case of obstruction during the use of the
platform the hoist installation must be checked
before reusing
- No modification of any components of the platform
equipment must be done.
WARNING:
Fig. 16a
Safway Universal End
Stirrup Inside and Right
View
Fig. 16
Safway Universal End
Stirrup Outside and
Left View
