MT100 User manual
TRACMT100UM001
-12 -
-Remove the external power and USB power.
-Press the reset key.
Note:
MT100 PWR LED will off.
3.3.
Reset Key
There is a reset key behind the SIM card cover. If the power wire is connected to vehicle
power, the system will reboot when the key is pressed; if the system is powered by the
backup battery and the power wire is not be connected to vehicle power, the system will
shutdown when the key is pressed.
3.4.
USB connector
There is a USB connector on MT100 which is beside the SIM card. With the USB
connector and the DATA_CABLE_M, user can configure the system or download
firmware. As long as the DATA_CABLE_M is plugged in, the system will boot.
3.5.
Power Connection
The red wire is power wire and the black wire is ground wire. The input voltage range for
this device is from 8V to 32V. The device is designed to be installed in vehicles that
operate on 12V or 24V systems without the need for external transformers.
Figure 3.
Typical Power Connection
3.6.
Ignition Detection
Table 5: Electrical Characteristics of Ignition Detection
Logical State
Electrical State
Active
5.0V to 32V