GETTING STARTED USING THE 100 AMP CONTROLLER
(If you have the 80 amp controller, please see pages 2,3)
The following is an explanation of the
Joystick
control. Press the round
OFF/ON Button
. If
the
Joystick
will not work, you will see the
Battery Lights
flashing. Refer to the flash code
section.
Battery Charger
Plug-in Location
Off/On
Otherwise, you should see the
Battery Lights
and the
Speed Indicator Lights
come on
without flashing. If the battery is fully charged,
you will see three red lights, four yellow lights
and three green lights. Also notice the
Speed
Indicator Lights
(1-5), indicating what speed
range the unit is in, one light being the slowest
speed available.
SELECTING SPEEDS
Press the
Speed/Mode Selector
button. You should see the
Speed Indicator Lights
flash. Move the
Joystick Lever
to the
right to increase speed, and to the left to decrease speed. To
operate in that speed, simply move the Lever forward or back. You can also
change speed while moving by pressing the
Speed/Mode Selector
button. The
Joystick has a total of five speeds.
( NOTE:
beginning operation in speed “1” or “2” lights is advisable until you are
familiar with the operation of the
Joystick.)
DRIVING THE IRV 2000 WITH THE JOYSTICK
Moving the Joystick forward will drive the
IRV 2000
forward. If you push the
stick just a little, you will go slow. If you push it a lot, you will go as fast as the
Speed Indicator
is set. If you move the stick a little to the left or right, you will
turn in that direction in a large circle. If you move it a lot, you will turn very short.
If you pull back on the stick, you will go backwards. If you release the Joystick
you will stop abruptly.
Try to move the Joystick very smoothly to avoid sudden jerks.
Page 4
03-29-02
Battery
Lights
JoyStick
Lever
Wheel Location
Lights
Speed/Mode
Selector
MODE
Speed Indicator
Lights
Horn
Button
