Trac About IRV2000, Owner'S Manual

Page: 6 / 45

INSTRUCTIONS TO OPERATE THE IRV2000
The Instructions of Operation are intended for you to have the most fun and the least
amount of frustrations while you operate the
IRV2000 . Please read the first 3 pages AND
page 11 of this manual before attempting to operate your new machine.
Keep in mind that the IRV2000 weights about 400 pounds without an operator. It can
cause damage to persons and property if not operated properly.
You can mount the IRV2000 from either side of the seat simply by raising the arm of the
seat. Sit down, spin in the seat and lower the arm rest. FASTEN YOUR SEAT BELT.
YOU ARE READY TO GO WHERE YOU WOULD LIKE TO GO!! The following
topics will explain the operation of each element of the Joystick controller.
GETTING STARTED USING THE 80 AMP
CONTROLLER
(If you have the100 amp controller, please see pages 4,5)
The following is an explanation of the Joystick
control.
Press the long
I|O button . If the Joystick will not
work, you will see a little red light flashing on the
Key Location . Touch the magnetic key on the Key
Location red light . This will allow the Joystick to
activate. (If you want to re-lock the Joystick, have
power on and touch the magnetic key on the
Key
Location red light.)
You will also see the Battery Lights come on. If
the battery is fully charged, you will see two red
lights, two yellow lights and two green lights. You
will see in the
Speed Indicator window the speed number or actuator letter. “ A” or “ b”
SELECTING SPEEDS
Press the Speed Selector until you see a “1” appear in the Speed
Indicator window. If you press the Speed Selector again, you will
see a “2” appear in the window.
The Joystick has a total of five speeds. The higher the number the faster the
IRV 2000
will go. To change to a lower speed you must continue to press the button through the
speeds and letters to obtain the desired speed. You will see a letter appear after speed “5”.
Refer to the section WHEEL POSITIONS for an explanation.
( NOTE: beginning
operation in speed is advisable “1” or “2” until you are familiar with the operation of the
Joystick.)
Speeds are the result of power levels. If you need more power you need to select a higher
speed setting and then adjust the ground speed by moving the lever slightly.
Page 2
03-29-02
Selector
Speed
Battery Charger
Plug-in
Battery Lights
System
Status
LED
Speed Indicator
Key Location
Joy Stick
Speed
Selector
1/0
Off-On
Horn
Power Plug-in