TQC Sheen GLOSSMETER GL0010, Operating Instructions Manual, Page: 5 / 32

5 |
2.1 Meaning of Symbols
The following symbols for dangers are used in this instruction manual.
2.2 Availability of Safety Information
The instruction manual should be kept in proximity to where the instrument operates and should be visible
and accessible at any time of operation.
In addition to the information contained in the instruction manual, general and local regulations for accident
prevention and environmental protection shall be kept available and observed. Always ensure all guidelines
in respect of safety and dangers on the instrument are in readable condition.
Avoid using it in over-high or over-low temperature environment Avoid humidity.
•
Though robust in design, this instrument is precision-machined.
•
Never drop it or knock it over.
•
Always clean the instrument after use.
•
Clean the instrument using a soft dry cloth. Never clean the
•
instrument by any mechanical means such as a wire brush or
•
abrasive paper. This may cause, just like the use of aggressive
•
cleaning agents, permanent damage.
•
Do not use compressed air to clean the instrument.
•
Always keep the instrument in its case when not in use.
•
We recommend annual calibration.
2.3 Dangers from Electrical Energy
• Work on the electrical supply may only be done by a qualified electrician.
• The electrical equipment of the instrument must be checked regularly. Loose connections and cables
damaged by heat must be corrected immediately.
• Always make sure the instrument’s power is turned off while adjusting any electrical component.
Make sure that no paint or other liquids are spilled on the electronics and optics.
2.4 Modifications to the Equipment
• Any modifications or additions or alterations to the instrument may solely be made with permission from
the manufacturer otherwise the warranty will be void.
• Instruments which are not in fault-free condition must immediately be switched off
• Only use replacement parts from the original supplier. Parts used from other sources aren’t guaranteed to
take the loading and meet the safety requirements.
Possible immediate
danger to the life or
health of personnel.
A dangerous situation
could be caused.
Special tips and
particular
information.
2 SAFETY INSTRUCTIONS