Page 23
10.2.2 ppM (mg/L) Configuration
1. Set the
ppM
jumper in the terminal area to be closed, as shown below.
ppM
or
% Sat
J4
2. (a) Remove the function knob and the four screws at each corner of the
front panel. Remove the front panel.
(b) The
Decimal Point
jumpers are three pairs of jumpers, located at the
top left hand side of the display.
Set the
Decimal Point
jumpers as shown below.
3. Ensure that the Red and Blue of the sensor cable are connected to terminals 1
and 2 (see the connection diagram in section 3.1).
