TP UP-PN24S, User Manual

Page: 7 / 25

１０
2) Serial Port Signal Definition
Pin Signal Source Description
1 GND Printer Signal ground
2 RXD Host Printer receiving data sent by host
3 TXD Printer Printer send data to host
4 GND Printer Signal ground
5 RTS Printer
“Mark” indicates printer is busy and can’t receive
data; “Space” indicates printer is ready to receive
data.
6 CON Printer
Connect with Pin1, set to RS-232C serial
interface mode
Mark=logic
“
1
”（
EIA level -3 V~-15V
）
Space=logic
“
0
”（
EIA level +3V~+15V
）
3) Connecting with Personal Computer
Figure 2-6 Connecting with PC
4) Communication Parameters:
Baud rate: 9600bps
Handshaking: RTS/CTS
Data Bit: 8
Parity: none
Stop bit: 1
１１
2.6.2 IrDA Infrared Interface:
IrDA works in semiduplex mode wireless. To communicate the IrDA
infrared transmitter and receiver of the host should aim at the infrared window
of the printer.
Communication parameters are following as:
Baud rate: 9600bps
Data bit: 8
Parity: none
Handshaking: none
Distance: 1m(max.)
View angle: 30
°
2.7 Operation of Indicators and Buttons
TP UP-PN has two indicators: the left one is a dichromatic light, red light
indicate charging the battery green light indicate printer under working, the
right one is a error indicator, and lights or flash when error occurs.
The power indicator turn green when turn on the printer.
The status indicator flashes when paper run out or Black Mark Detect failure.
Error indicator flashes as shown as figure 2-7(high level indicate the light
lights).
Figure 2-7 Error indicator flash mode
TP UP-PH has two buttons shown as figure 2-8: ON and LF. Their
functions are following:
Paper end
BM detect error