TL-WR702N
150Mbps Wireless N Nano Router
- 10 -
Chapter 3. Quick Installation Guide
This chapter will show you how to configure the basic functions of your TL-WR702N 150Mbps
Wireless N Nano Router using
Quick Setup
Wizard
within minutes.
3.1 TCP/IP Configuration
The default IP address of the TL-WR702N 150Mbps Wireless N Nano Router is 192.168.0.254.
And the default Subnet Mask is 255.255.255.0. These values can be changed as you desire. In
this guide, we use all the default values for description.
Connect the local PC to the LAN/WAN port of the Router. And then you can configure the IP
address for your PC in the following way.
¾
Obtain an IP address automatically
1) Set up the TCP/IP Protocol in "
Obtain an IP address automatically
" mode on your PC.
If you need instructions as to how to do this, please refer to
Appendix B: "Configuring the
PC”.
2) Then the built-in DHCP server will assign IP address for the PC.
Now, you can run the Ping command in the
command prompt
to verify the network connection
between your PC and the Router. The following example is in Windows XP.
Open a command prompt, and type
ping 192.168.0.254
, and then press
Enter
.
¾
If the result displayed is similar to the Figure 3-1, it means the connection between your PC
and the Router has been established well.
Figure 3-1 Success result of Ping command
¾
If the result displayed is similar to the Figure 3-2, it means the connection between your PC
and the Router has failed.
