8
8. DISASSEMBLING
WARNING
•
Make sure to disconnect the power source before disassembling the unit.
•
Carefully disassemble the unit. Do not touch evaporator and condenser directly or you may cut or injure your
hands.
CAUTION
•
Do not touch the compressor, the discharge pipes, or any parts that may be subjected to high temperature,
before the temperature becomes low .
1. Remove two (2) screws
\
from the front cover
N
and remove two screws
]
from the top of the rear
panel
I
to remove the front cover. Lift up the front
cover and disconnect the connecters of the circuit
board and the ionizer (Type A only).
2. Remove six (6) screws
\
from the back of the front
panel
G
to remove the front panel.
In this condition, you can check all of the parts.
3. Remove three (3) screws
]
from the bottom of the
rear panel
I
and two (2) screws
]
from the central
part of the rear panel (inside). Remove two (2)
screws
\
from the top of the rear panel and three
(3) screws
\
from the central part of the rear panel
to remove the rear panel.
1-2
3
\
]
\
\
G
N
I
\
\
]
]
G
N
I
TAD-T32G (Service Manual) 07.1.17 3:03 PM ページ 8
