BEFORE IGNITION
4.
OPERATION
SECTION E:
OPERATION
MANUAL OPERATION
Open the Valve(s)
Open the valve(s) of the external fuel tank.
Start the Fuel flow
If using heater for the first time, or after heater has been out of fuel, press
the red reset button once for a period of one second in order to send fuel
to the fuel sump.
Plug in the Heater
Plug heater into a 120V AC electrical outlet.
Note:
Do not connect to an outlet shared with other appliances.
C. Position timer selector to “CLOCK/TEMP (NORMAL POSITION)” after clock setting is completed.
Current time will be shown on digital indicator.
In the event of a power failure over ten (10) seconds, all clock and timer settings are cancelled.
Digital indicator will flash “PM 12:00” when heater is off, or “AUTO” lamp will flash when
heater is on and in automatic operation, after is power is restored. However, no indications
when heater is in manual operation. At this point, you need to reset all time and set-back
functions.
Note:
“MANUAL” operation means that the set-back will not be in use but in ”NORMAL” mode.
Operation of the heater is under the direct control of the user (“AUTO” switch is off). Heat output will,
however, be automatically adjusted in accordance with the room temperature registered by the
temperature sensor.
Operation of Laser Heater can be controlled manually by the user - “MANUAL” operation (NORMAL mode
only) or run automatically by the programming - ”AUTOMATIC” operation (NORMAL mode and SET-BACK
mode).
3.
Set Clock
Important: Clock on the heater always
must be set to current time.
A. Position timer selector to “CLOCK SET”.
B. Press “HOUR” and “MINUTE” button
of TIMER/CLOCK SET to correct time.
Important: Check for the AM or PM
i n d i c a t o r s , t o i n s u r e t h e
correct time.
4.
Note:
Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
1.
2.
“HOUR” or “MINUTE” button will
change the time every one (1)
unit. Holding the button
continuously will cause the time
to change rapidly.
Note:
ROOM
SET
TEMP
BURNER
LO MED HIGH
BURNING MODE
TIME/CLOCK SET
TEMP SELECT
HOUR
BURNER
(NORMAL POSITION)
CLOCK SET
CLOCK / TEMP
START
SET-BACK
50
10
70
21
90ºF
32ºC
END SET-BACK
SET - BACK
NORMAL
AUTO
AM PM
HOUR
AUTO
8. ON/OFF lamp
10. Normal temper-
ature lamp
1. ON/OFF switch
5. Timer selector
3. Temperature
selectors
11. Set-back temper-
ature lamp
4. Timer & clock set
7. Burning mode lamp
9. Auto lamp
6. Digital Indicator
2. Auto switch
Reset Button
9
Laser 60AT (E) 11.3.3 0:59 PM Page 9
