SAFETY TIPS FOR INSTALLATION
Important:
In areas of heavy
snow falls, ground
surface clearance must
be increased according
to average snow falls.
Important:
In open area
with strong
wind, a wind
break may be
necessary.
Follow the safety tips below when planning the installation of your Laser 60AT.
1. Intake and exhaust flue pipe openings must be fully exposed to outside air.
Do not vent into chimney garage, basement under the floor, or into any
enclosed area.
2. Do not install flue pipe in close proximity to other objects or materials (See
page 23).
3. Before making a hole in your wall for the flue pipe, make sure the area is free
of electrical wires, gas pipes and other obstacles.
4. Do not install flue pipe where it will be exposed to heavy snow collected
leaves
or strong drafts.
5.
Do not install the flue pipe
down from the heater.
6. Total length of extension pipe between heater and flue pipe must be no
greater than 10 ft. and 3 bends may be used.
NOTE: When using extension pipes always cover the exhaust pipe with the
insulating cloth cover.
7.
A B-Vent shall not be used in the vent system.
8.
Installing in the mobile home, the eaves non oumbustible must be necessary.
1ft.
Eaves
(Non Combustble)
1ft.
Long
extension
kit
Snow
Snow
Must be
higher
24"(Min.)
Wind
break
Strong
wind
Gasoline
Kero- sene
Gas pipe
22
Laser 60AT (E) 11.3.3 0:59 PM Page 22
