Toyota T100 1996, Service Manual, Page: 1489 / 2062

SA0FL − 01
FA0028
R12261
Sealant
R04135
MP Grease
Inner
Bearing
Outer
Bearing
Cap
− SUSPENSION AND AXLE FRONT AXLE HUB (2WD)
SA − 19
1996 TOYOTA T100 (RM449U)
INSTALLATION
1. INSTALL STEERING KNUCKLE
(a) Support the lower suspension arm with a jack.
(b) Install the steering knuckle to the upper ball joint and nut.
(c) Push down the upper suspension arm and steering
knuckle and install the steering knuckle to the lower ball
joint and nut.
(d) Torque the upper ball joint nut.
Torque: 108 N·m (1,100 kgf·cm, 80 ft·lbf)
(e) Torque the lower ball joint nut.
Torque: 142 N·m (1,450 kgf·cm, 105 ft·lbf)
(f) Install 2 new cotter pins.
2. CONNECT KNUCKLE ARM AND TO STEERING
KNUCKLE
(a) Clean the threads of the bolts and steering knuckle with
toluene or trichloroethylene.
(b) Apply sealant to the bolt threads.
Sealant:
Part No. 08833
− 00070, THREE BOND 1324 or equiva-
lent.
(c) Tighten the 2 bolts.
Torque: 183 N·m (1,870 kgf·cm, 135 ft·lbf)
3. INSTALL DUST COVER
Install the 3 bolts and tighten them.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
4. PACK BEARINGS WITH MP GREASE
(a) Place MP grease in the palm of your hand.
(b) Pack grease into the bearing, continuing until the grease
oozes out from the other side.
(c) Employ the same manner around the bearing circumfer-
ence.
5. COAT INSIDE OF HUB AND CAP WITH MP GREASE