SCION tC
2008-
ILLUMINATED
DOOR
SILLS
Procedure
Page 7 of 17 pages
Issue: C 06/13/07
(i)
Locate the driver side illuminated door sill.
Remove tape liner from back of lighted side
sill. (Fig. 2-5)
(j)
Install lighted side sill to vehicle.
(1)
The word “SCION” should be right side
up reading from the outside of the
vehicle.
(2)
Be sure locating pin aligns correctly with
vehicle alignment holes. Gently place the
sill on the rocker surface and press the
sill piece toward the pinch weld to relieve
any slack.
(3)
Once the sill is in the proper position,
apply firm pressure to the sill, working
from the center outward, making sure the
perimeter of the sill is adhered to the
rocker surface. (Fig. 2-6)
(k)
Run the power wire from lighted side sill
over the thin foam tape attached to the pinch
weld. (Fig. 2-7)
(l)
Reinstall door weather stripping to pinch
weld. (Fig. 2-8)
Tape Liner
Fig.
2-5
Locator Pin
Alignment Hole
Fig.
2-6
Fig.
2-8
Weather Stripping
Locator Pin
Fig.
2-7
