TOYOTA 4RUNNER
2020 –
DASH CAMERA
PROCEDURE
Page 14 of 24
Issue D: 11/06/19
b.
Route the Wire Harness
Ground Wire behind the
reinforcement, locate “G1”
Ground attachment upper
right side of the Glove box
area and remove the Bolt.
c.
Place the Wire Harness
Ground Terminal
underneath
the vehicle ground terminal
and reinstall the Bolt.
Torque:
75 in•lbf (8.5 N•m).
NOTE:
Place the Wire Harness
Ground Terminal behind the vehi-
cle ground terminal at 90 degrees.
e.
Disconnect Connector F42
(40P, White) located on the
left side of the blower motor.
f.
Remove the electrical tape
closest to the connector
securing the wires.
10mm Socket, Torque Wrench
Fig. 3-2
d.
Secure both the Dash
Camera wire and Ground
wire to the vehicle harness
with 1 Wire Tie (#5).
Side Cutters
Fig. 3-3
Fig. 3-4
5
