TOYOTA 4RUNNER
2020 –
DASH CAMERA
PROCEDURE
Page 11 of 24
Issue D: 11/06/19
Tape Measure/Ruler, Masking Tape
Fig. 2-5
Fig. 2-4
g.
Slide the protection vinyl tube
until it covers the whole dash
camera wire up to the Wire
Channel as illustrated.
NOTE:
Harness has overlapped
vinyl tube. Slide the tube nearest
to the camera until position
shown in fig. 2-4. Do not cut the
vinyl tube.
h.
Use Glass Cleaner to clean
the inside Windshield of the
indicated mounting location.
DIO Only (steps i-j)
i. Measure 75mm to the left of
the Rearview Mirror channel
and mark it with Masking
tape.
j. Measure 70mm from the
edge of the shade-band and
mark it with Masking tape.
NOTE: Do not touch the
camera lens during install.
c.
Measure the Wire Channel to
90mm length and cut to size
as shown.
d.
Insert the Dash Camera Wire
into the Wire Channel, then
insert the Wire Channel into
the Dash Camera as shown.
e.
Tighten the screw making
sure the Camera angle
indicator is pointing at the
3rd Mark as shown.
f.
Install the Dash Camera’s
side cover by aligning with
slots in camera housing, then
turn clockwise to lock.
Tape Measure/Ruler, Scissors, Phillips Screwdriver
Fig. 2-3
3rd Mark
Camera Angle
70mm
75mm
(Shade-band)
Larger end
Cut
90mm
