TOYOTA CAMRY
(GAS AND HV)
2022 -
DASHCAM
(Digital Video Recorder)
Procedure
Page 13 of 16 pages
Issue: A 07/25/2021
13. Reinstall Overhead Console
(a) Re-connect harness for the overhead
console, test map lights and sunroof
control if equipped. (Fig 13-1)
(b) Check all console clips are in good
condition and are present on the
console. If any are still installed in the
roof of the vehicle and have separated
from the console, a panel tool with a
forked end can be used to pry them out,
then reinstall in the console. (Fig 13-2)
(c) Reinstall the console by first inserting the
tabs to the rear (of the car) of the
opening and then rotate upwards in the
front of the console to pop in the two
clips. Observe marks in headliner for
alignment references. Carefully push in
to place to lock.
(d) Note: Be careful aligning the clips to
holes to avoid damage.
14. Reinstall Sun Visor Clips
(a) Insert the clip bases on both sides of the
map light console, they should snap
securely into place.
(b) Insert the visor clips starting with the
opening for the visor in the anti-clockwise
position similar to how they were
removed, then rotate clockwise to lock
back into place.
(c) Note: The direction is the same for both
sides. It is not mirrored.
15. Reconnect Vehicle Battery
(a) Reconnect the Negative Battery Cable.
(b) Torque to 5.4 N•m (48 in•lbsf)
(c)
CAUTION:
Do not touch the positive
terminal with any tool.
16. Owner’s Manual
Place the Owner’s Manual
(“
Quick Start Guide
”) in the glove box with
the other vehicle owner’s manuals.
Torque Wrench
Fig. 15-1
Fig. 13-1
Fig. 13-2
Fig. 14-1
