TOYOTA CAMRY
(GAS AND HV)
2022 -
DASHCAM
(Digital Video Recorder)
Procedure
Page 12 of 16 pages
Issue: A 07/25/2021
12. Route / Bundle Wire Harness
(a) Before proceeding with securing the
harness, confirm that both connector
pairs and fuse holders have been
protected with the provided foam tape.
Use the provided foam tape to minimize
any potential rattle concerns. (Fig 12-1)
(b) Secure the Y-harness and fuse holders
against the existing harnesses at the
front edge of the map light / sunglasses
pocket opening. (Fig 12-2)
(c) Secure the Dashcam Pigtail harnesses
against the existing harnesses on the
driver’s side of the map light / sunglasses
pocket opening. Loop and bundle them
as required. Arrange this in a way that
does not obstruct the console being
reinstalled. (Fig 12-2)
(d) Ensure that the connection for the
console is still free to be connected and
that the bundled harnesses are not
obstructing the console map light
connector. (Fig 12-3)
(e)
Note: Take care not to cause bulging
in the headliner. Some adjustments to
the bundle may be required to avoid
bulging the headliner.
(f)
Note: Do not block access to the clip
holes in the body structure or the roof
console may not fit properly.
(g) After securing, be sure to snip off extra
cable-tie length to prevent any rattles or
squeaks from the loose end of the cable
tie strap.
Fig. 12-1
Fig. 12-2
Fig. 12-3
