Toyota Bluetooth hands-free system, Owner'S Manual

Page: 15 / 176

14 Bluetooth
®
4.5. Using the voice recognition (VR)
features
A press and release of the MULTI-FUNCTION button will activate a voice recognition session.
When you begin a VR session, you hear a prompt and then a short beep. The beep - also known
as a listening prompt - indicates that the hands-free system is waiting for a verbal command from
you.
The voice recognition hands-free system has main menus -
• Setup menu – Always available except when in a call.
• Phone menu – Only available when a handset device is connected.
• Call menu – Only available when a call is active.
Depending on which menu you are in, saying the predefined commands will allow you to operate
the hands-free system.
The hands-free system includes help prompts in every menu. While learning to use the hands-free
system, or whenever you need a reminder of the command list, say “HELP”. Some menus have
“ADDITIONAL HELP”
.
You can say “REPEAT” whenever you are prompted for a Yes or No command. The hands-free
system will repeat the question.
Note: A press and release of the MULTI-FUNCTION button during a VR prompt will
immediately stop the VR prompt and go the listening prompt.
You can say “CANCEL” to return to the last voice recognition menu.
You can say “ExIT” to exit the voice recognition session.
Or use the UIM: A press and release of the END button will also exit the voice recognition
session.
Note: Any system prompts enclosed in {} represent prompts that are suppressed in Expert
mode.
Adjusting the voice recognition volume
At any time except when in a call, press and release a VOLUME UP/DOWN button to increase/
decrease the voice recognition volume by a single level.
Tones are played to indicate when the maximum and minimum volumes are reached.
EN_BT_IHF1700_OM.indd 14 26-10-2007 13:42:34