Toyota 1993 MR2, Wiring Diagrams

Page: 67 / 189

71
* EI (ESA, ELECTRONIC FUEL ADVANCE)
THE EI (ESA) SYSTEM MONITORS THE ENGINE REVOLUTIONS USING THE SIGNALS (INPUT SIGNALS (1, 4, 5, 10, 11)) INPUT TO
THE PCME (ECU) FROM EACH SENSOR. BASED ON THIS DATA AND THE PROGRAM MEMORIZED IN THE PCME (ECU), THE MOST
APPROPRIATE IGNITION TIMING IS DECIDED AND CURRENT IS OUTPUT TO TERMINAL IGT OF THE PCME ECU. THIS OUTPUT
CONTROLS THE IGNITER TO PRODUCE THE MOST APPROPRIATE IGNITION TIMING FOR THE DRIVING CONDITIONS.
* ISC (IDLE SPEED CONTROL) SYSTEM
THE ISC SYSTEM INCREASES ENGINE SPEED AND PROVIDES IDLING STABILITY FOR FAST IDLE–UP WHEN THE ENGINE IS COLD
AND WHEN THE IDLE SPEED HAS DROPPED DUE TO ELECTRICAL LOAD, ETC. THE PCME (ECU) EVALUATES THE SIGNALS FROM
EACH SENSOR (INPUT SIGNALS (1, 4 TO 8, 11, 12)), OUTPUTS CURRENT TO TERMINALS ISCO AND ISCC, AND CONTROLS THE ISC
VALVE.
* EGR CONTROL SYSTEM
THE EGR CUT CONTROL SYSTEM CONTROLS THE VSV (FOR EGR) BY EVALUATING THE SIGNALS FROM EACH SENSOR INPUT TO
THE PCME (ECU) (INPUT SIGNALS (1, 4, 10)) AND BY SENDING OUTPUT TO TERMINAL EGR OF THE PCME (ECU).
* A/C CUT CONTROL SYSTEM
WHEN THE VEHICLE SUDDENLY ACCELERATES FROM LOW ENGINE SPEED, THIS SYSTEM CUTS OFF AIR CONDITIONER
OPERATION FOR A FIXED PERIOD OF TIME IN RESPONSE TO THE VEHICLE SPEED AND THROTTLE VALVE OPENING ANGLE IN
ORDER TO MAINTAIN ACCELERATION PERFORMANCE.
THE PCME (ECU) RECEIVES INPUT SIGNALS (5, 6), AND OUTPUTS SIGNALS TO TERMINAL ACT.
* FUEL PRESSURE CONTROL SYSTEM
THE FUEL PRESSURE UP SYSTEM CAUSES THE VSV (FOR FUEL PRESSURE UP) TO COME ON FOR HIGH TEMP. STARTS IN
ORDER TO INCREASE THE FUEL PRESSURE, IMPROVE STARTABILITY AT HIGH TEMPERATURES AND PROVIDE STABLE IDLING.
THE PCME (ECU) EVALUATES THE INPUT SIGNALS FROM EACH SENSOR (1, 2, 5, 11), OUTPUT CURRENT TO TERMINAL FPU AND
CONTROLS THE VSV.
3. DIAGNOSIS SYSTEM
WITH THE DIAGNOSIS SYSTEM, WHEN THERE IS A MALFUNCTION IN THE PCME (ECU) SIGNAL SYSTEM, THE MALFUNCTION
SYSTEM IS RECORDED IN THE MEMORY. THE MALFUNCTIONING SYSTEM CAN THEN BE FOUND BY READING THE DISPLAY
(CODE) OF THE CHECK ENGINE WARNING LIGHT.
4. FAIL–SAFE SYSTEM
WHEN A MALFUNCTION OCCURS IN ANY SYSTEM, IF THERE IS A POSSIBILITY OF ENGINE TROUBLE BEING CAUSED BY
CONTINUED CONTROL BASED ON THE SIGNALS FROM THAT SYSTEM, THE FAIL–SAFE SYSTEM EITHER CONTROLS THE SYSTEM
BY USING DATA (STANDARD VALUES) RECORDED IN THE PCME (ECU) MEMORY OR ELSE STOPS THE ENGINE.